Wednesday 15 March 2017

65 MILE LEG STRETCH IN TO THE CHILTON’S. Mango Velombile





65 MILE LEG STRETCH IN TO THE CHILTON’S.
CHEEM AND AROUND THAT AREA HIGH LIGHT OF THE RIDE

LONG VIDEO

Friday 24 February 2017

MANGO AXLE PROBLEM





AXLE PROBLEM


OK I have been very quiet about this, as it’s a bit
embarrassing, but now I will reveal all.


Sometime after I got the mango, and got some miles on it
there was a noise from the freewheel


So I took the back wheel out to have a look and changed it.
What I did not realise is when I took the axle out the large nut came undone
and I did not realise when I replaced it left out a 2m washer that was behind
it and run up against the baring, so when I put the axle back in and did it up
on the swinging arm side it left a gap and there for there was play in the
wheel on the axle, and I did not spot it. 


So for around a year I was riding it like that, and in the
end I started having problems with the new freewheel to the point when I
finally took it off to have a look it flee apart as I took it off! Sinner
rushed me a new freewheel out, and I set to putting it on and replacing the
wheel and axle, then When I was inspecting it I noted the free play, and had a
word with harry at Sinner. And he pointed out that it should not be like that
and then I realised as he explained that the nut should have a washer on it and
I knew there was not one there. So I attempted to take the wheel off again
after I had run it on a test ride, that was a mistake, as when I got back and
started to dismantle it again to have a look if I could replace the washer, as
I had re lock tighten the nut back on!


Well that’s when the problem started the axle would not come
out? 8 hrs later I gave up really I tried for 6 hrs to get it out! Then I asked
Harry as the only way I could think was to saw threw the axle!


Harry explained that they had thought of this and that is
why there is a threaded hole in the nut inner, to pull it out, I had mist that
completely ?!  Fool I am. Sinner rushed
out an axle for me and I got it yesterday, so to day I laid out all the tools
and had planned out how to attack the axle using the thread, I will leave it to
the Video now, as I made a video to explain what happened to day.